The RP110 can monitor up to 4 separate data channels and can be trained to learn new sentences. New sentence formats can be downloaded into re-programmable, non-volatile flash memory using the RS-232 serial data port of a PC compatible running Windows 95 or Win98. Free software provided on floppy diskette.
Up to ten new sentences can be stored in the on-board flash memory - these can be re-programmed as many as 1 million times so your RP110 will never go obsolete.
Simple mounting: mounts in a standard 2-1/8" round instrument hole.
Five levels of backlighting can be selected and all set-up information is automatically saved to non-volatile memory. The RP110 works on both 12 and 24 VDC systems. For those with little or no knowledge of repeaters and NMEA 0183 signals, here is a short tutorial that describe the usefulness of the RP110: Most CruzPro instruments have an output terminal upon which the instrument sends out a serial data stream of information. This signal is called NMEA 0183, a standard defined by the US National Marine Electronics Association to enable instruments from one manufacturer to communicate with instruments from another manufacturer. A GPS that outputs NMEA 0183 can send position, speed and heading data to an electronic autopilot, for instance. The autopilot uses this information to steer the boat. For another example, a speed log (such as the CruzPro SLT30 or SLT110) can output speed data to a wind instrument so the wind instrument can compensate for boat speed to calculate TRUE wind speed and direction as apposed to APPARENT wind speed and direction. Since CruzPro instruments, such as the T30 temperature gauge, OP30 oil pressure gauge, RH30 RPM gauge, etc. all output NMEA 0183 data, you can connect up to four of these instruments to one RP110 remote data repeater and see the same data at a remote steering station without having to replicate the entire set of instruments. In fact, you are not limited to seeing data only from CruzPro instruments - the RP110 will repeat data from anyone's NMEA 0183 instrument. You could connect a radar or depth sounder from Raytheon or Standard Horizon to the RP30 and it will repeat that information as well. The RP110 is already factory pre-programmed to repeat 200 "standard" pre-defined NMEA 0183 sentences. There is a "flash" memory (re-programmable) that allows the user to add up to 10 more new sentences. You simply connect the RP110 to a computer's RS-232 output port and use the PC computer program that is provided with the RP110 and "teach" the RP110 new sentences when required. This allows the RP110 to recognize and repeat future NMEA 0183 sentences that have not yet been defined today. Therefore the RP110 will not go obsolete.
