PY60 Digital Pyrometer complete with alarm and sensor

Zoom

Our Price: £174.00(Exc. 20% VAT)(£208.80 Inc. VAT)

Round or Square Bezel:

The PY60 pyrometer displays engine exhaust gas temperature in degrees F or C. It comes with an 1100 deg C type K thermocouple. Low and High temperature alarms can be set over the entire range of the instrument. When activated, the PY60 built-in 85 dB alarm will sound and the display will flash. The alarms can be enabled or disabled with a single key press. Five levels of backlighting can be selected and all set-up, calibrations constants, alarm values and Max. temperature seen is saved to non-volatile memory. Data is output on an NMEA 0183 compatible serial data output.

All constants and calibrations are pre-set during manufacture but you may alter these settings to suit your particular needs. Calibrations can be altered over a wide range using the front-panel switches. All information is automatically saved to non-volatile memory.

With a press of the button you can display exhaust gas temperature (in deg F or C), High and Low temperature alarm set-points, and Maximum temperature seen (since last reset).

The PY60 draws only 0.017 amps and 5 levels of backlight (including OFF) can be selected from the front panel and is saved to non-volatile memory.

The PY60 outputs temperature on the standard NMEA 0183 serial data line at 4800 BAUD. This ASCII information can be used to log performance or repeat the display information at a remote location on the CruzPro RP30 and/or RP110 data repeaters (see www.cruzpro.com/rp30.html and www.cruzpro.com/rp110.html). If NMEA 0183 serial data is not required, then the output terminal can be programmed as an external alarm output pin.

Specifications

Operating Voltage:: 9.5 - 33.0 VDC
Current Drain:: 0.018 amps nominal
Display:: 4 digit LCD, 5 levels of backlighting
Data:: Temperature 32 to 2000 degrees F; (0 to 1100 deg C) +/- 1%; Maximum Temperature seen memory
Inputs:: Thermocouple (type K provided)
Data Ouput:: NMEA 0183 serial 4800 BAUD
Alarms:: Built-in 85 dB audible alarm. Settable high and low temperature alarms
Size:: 2.5" dia X 4.1" deep (61mm x 104mm)
Mounting:: 2-1/8" (55mm) round hole